IT consulting
For more than 10 years a profitable partnership in
analysis, design and realization of informatics solutions for inside
applications and for our customers all over the world.
SOFTWARE AQ2TB
AQ2tb is the software installed on
Giussani's test benches that allows to perform
hydraulic and mechanical tests on
sanitary taps, fittings, pipes and hydraulic devices in accordance with the main
I nternational Standards.
The software acquires in real time all the physical parameters that characterize
each test and provides a detailed graphical representation.
It is available in several languages and allows to use different measurement units.
The main characteristics of the AQ2tb software are:
- Display in real time of the test via multi-curve graphs.
- Synoptic representation of the hydraulic system of the bench.
- Zoom function to analyse in detail the graphs acquired.
- Module for entering the data of each test.
- Possibility of generating a test report at the end of each test,
containing the most significant graphs and data.
SPECIFIC TEST
SOFTWARES
AQ2TB-COMBILAB+
Universal application for hydraulic tests for the verification and analysis
of the functioning of sanitary taps, single lever mixers, thermostatic mixers
and hydraulic devices such as valves, aerators and diffusers.
AQ2TB-STATICAUT
Software application to evaluate the tightness of the device under test when
subjected to static pressure.
The software also allows to evaluate the maximum pressure that the device under test
can reach before the burst.
AQ2TB-PULSEAUT
Automatic software for performing cycling pressure tests with water circulation (pressure
range: 0,2÷12 bar) and water hammer tests without water circulation.
AQ2TB-FLOW-LIN
Automatic software for flow-rate tests with linear increase of pressure.
Up to 6 tests can be viewed on the same chart and repeated, changing the position
of the mechanism or the component under test.
AQ2TB-KV-LAB
Semi-automatic software for flow-rate tests and Kv coefficient calculation with measure
of pressure loss.
The operator manually increases the flow-rate of the device under test and the software
automatically associates, for each significant value of ΔP between the inlet and the
outlet of the component, the corrisponding flow-rate value.
AQ2TB-FLOW-STEP
Software for automatic step flow-rate test with adjustable pressure slope
and final tabulation of hot, cold and mixed water flow-rate, pressure and temperature.
AQ2TB-F+S-DRIVE
Software for fidelity (hysteresis) and sensitivity tests with motor control and
display of torque.
It evaluates water temperature and torque as a function of the angular position
of the control device.
AQ2TB-M-LAB-D08 & AQ2TB-M-LAB-NF+
Software for performing shut-off tests on thermostatic mixers, capable of detecting
hot water loss in case of cold water failure, in accordance with D08 and NF Standards.
The software measures the quantity of water collected
and calculates the final temperature variation.
AQ2TB-M-PROD-NF
Software for final testing of thermostatic cartridges and wall or flush
mounting thermostatic mixing valves.
It allows to performe a driven, complete and quick test procedure with an high productivity
per hour.
It is possible to adjust all the test parameters and condition.
AQ2TB-EN12293
Software for
BPV-T50-3-SWG thermal cycles test bench.
The software is suitable to perform thermal cycle tests on multi-layer piping assemblies
and fitting in accordance with the main Internation Standards.
It is possible to manage up to three test stations simultaneously.
AQ2TB-NOISE
Software for
BP-RUMORE test bench; it permits a real-time evaluation of the noise
generated by the device under test as a function of pressure and flow-rate.
The software shows in real-time the noise spectrum measured by the sound level meter
with A-weighting and corrected by the calibration matrix.
