Giussani
will be at
MCE 2012 from 27 to 30 March.
We will present the new test benches for sanitary faucets and hydraulic components with the possibility to perform endurance tests,
static and dynamic pressure tests and measurement of the noise generated.
38^ Mostra Convegno Expocomfort
Milano - Rho
Hall - 11
Stand - D50
BPV-T50-3-SWG
BPV-T series test benches are suitable to execute thermal cycle tests in accordance
with the EN 12293 and equivalent Standards on multi-layer piping assemblies, PE-X pipe
and fittings.
The bench makes it possible to operate with 3 test stations simultaneously,
using specific independent parameters for each station and a common thermal cycle.
Every test station is equipped with a 3 kN traction device with load cell to place pipes
in traction before starting the test and to adjust axial load force.
BPF100-SI
The bench is suitable to test fittings, multilayer, and flexible tubes, valves,
heat exchangers, sanitary taps and many others hydraulic components.
It is suitable to perform static tests up to 100 bar, cycling pressure tests up to 12 bar
and burst tests.
Test bench is equipped with work-station and AQ2tb dedicated software.
Pyros
Pyros125,
Pyros375 and Pyros650 are compact instruments for the calibration of temparture probes from -24 °C up to 650 °C.
The main features of these calibrators are the reduced weight, the compact and practical design and
the ease of use.
The new forced air ventilation device prevents overheating of the sensors and
reduces the temperature of the upper grid.
The large range of inserts available as standard and the possibility of realizing special
inserts on request make them suitable for the calibration of all common temperature
sensors.
Pulsar 35Cu
Pulsar-35Cu is a compact dry block calibrator used to
calibrate transducers, probes and temperature sensors.
It is
equipped with a PID microprocessor with a resolution up to 0,01 °C.
The oven consists of a metal block heated by a resistance which winds
around the outer surface of the block.
